Hello! Today I'd like to share a card I made for one of my nephews' birthdays. It's always a challenge to come up with an idea for a masculine card. However, I finally decided on making a slider card. I'll be making a couple more in the next few weeks for friends' birthdays. It takes a bit of work, but the end result is worth it.
I began with preparing my base card in GKD white card stock. A layer of GKD Cherry Red was added. This was then put aside.
Next, I began working on my focal panel by determining where I need to cut the slot for the slider. Using a die from Lawn Fawn Slide-on-Over die set, the slot was created. (If you don't have a slider die, the slot can also be made using a ruler to draw the outline for the slot and a craft knife to cut out the slot. Or the slot can be created by using the longest die from Spellbinders Labels Trio, using it to create the slot and then extending it with the same die).
At this point I took 4 pennies and adhered two together with a dimensional adhesive making sure the dimensional would be sized so as not to interfere with the pennies sliding in the slot. I did the same with the other two pennies. I put these aside to continue to work on the focal panel.
I created a "road" by taking GKD Black Onyx card stock and marking it with dashes using a white gel pen. This was adhered directly under the slider slot.
In the next step I found a digital wavy racing flag on line and printed out two of them. A pole was made from black card stock and one attached to each flag. These were then adhered with dimensionals to my focal panel. I added 2 small gears (cut with a Cheery Lynn Gears die) on either side of the flags.
My sentiment was personally composed and computer generated and then cut with a die from Avery-Elle Dotted Elle-Ments. In order that it fit properly on my focal panel, I cut a bit off the end. This was then adhered with dimensionals to the card.
Finally, using a die from Mariane's Classic Cars set, a car was cut in red mirror paper. I used black and white card stock to create the white-wall tires and cut a small circle in silver mirror paper for the center of each wheel. Then the penny "sliders" were inserted into the slider slot on the focal panel and a dimensional was attached to the center of each one and the car then adhered to it in two places (front and rear). A layer of white card stock was added to the back of the focal panel with dimensionals in order that the car image could slide freely back and forth.
My finished panel was then adhered to my prepared base card and my project was complete.
Hope you enjoyed this post. No matter what the theme, "sliders" are fun to make and sure to be enjoyed by any recipient. Thanks for stopping by and stay tuned for more posts to come.
Be sure to make it a great day!